Fendt 900 Varios Sensors Concerned compensate for mechanical and electrical tolerances in sensors, the sensors concerned must be calibrated.If a sensor is replaced, it must be calibrated.
What Required:
The following sensors and functions require calibration
1 Rear EPC calibration (depth control code 8001 and rear power lift position code 8002)
2 Calibration, EPC front (code 9001 and code 9002)
3 Calibration, crossgate lever (hydr. auxiliary valves) (code 1001)
4 Calibration, linear module 1 (hydr. auxiliary control vakve) (code 1003)
5 Calibration, linear module 2 (hydr. auxiliary control vawve) (code 1004)
6 Calibration, linear module 3 (hydr. auxiliary control valve) (code 1005)
7 Calibration, linear module 4 (hydr.auxiliary control valve) (code 1006)
8 Calibration, front axle suspension (code 7666)
9 Steering calibration (steering angle sensor code 2401/Autoguide control valve code 2403)
10 Calibration,rear PTO coupling time (code 6034)
11 Calibration,front PTO coupling time (code 7034)
12 Calibration,drive clutch pedal (code 4001)
13 Calibration,hand throttle pedal (code 2)
14 Calibration, travel range selector (code 4003)
15 Calibration, foot throttle pedal (code 4005)
16 Calibration, transmission ratio characteristic (code 4007)
17 Calibration, turbo-clutch function (code 4009)
18 Calibration, throttle pedal resolution (code 4010)
19 Calibration, heater valve (no code)
NOTE: Observe the calibration sequence.
Calibrations 1 to 11 and 19 can be performed in any order.
Calibrations 12 to 18 must be performed in sequence and en block (transmission calibration).The transmission emergency operation must not be switched on during calibration.(Transmission oil temperature higher than approx.409C during transmission calibration).If incorrect values are detected or the conditions are not met, an ERROR message appears If calibration completes successfully, OK is displayed, and the new sensor settings are stored.Data are only accepted when ignition key is turned to position “0”.(Wait for at least 15 seconds before switching on the ignition again!)
Menu levels on the A007 instrument panel
